Furuno 511 Manual do Utilizador

1REFERENCE MANUAL AUTOPILOT NAVPILOT-500/511/520 WIND MODE 1. OPERATION...

1. OPERATION 8 Wind direction(apparent)5050 Tacking maneuver when heading is 50º You can set the interval between pressing the course control knob an

1. OPERATION 91.2.3 Setting the tack timer You can set the timing between pressing the course control knob and starting actual turning. 1. On the

1. OPERATION 10 1.3 DODGE Mode The DODGE mode is useful in situations where you need to quickly take control of the helm to avoid an obstruction. 1.

3. STEERING MODE 11NHeading value set(HDG)Available range set(BND)Range where the alarm occurs Heading change alarm maneuver 1. Rotate the course c

1. OPERATION 12 1.4.3 Setting the true wind speed alarm The true wind speed alarm warns you when the true wind speed is over or under the wind speed

3. STEERING MODE 131.5 Error Messages Your equipment displays error messages to alert you to potential equipment trouble. Error message Meaning Re

14 2. SETTING OF FI-30 When connecting with FI-30 server to input wind data, set it as below. FI-30 NMEA output setting: update rate of AWA/TWA =

Trim the sail to the wind always optimally.Wrong sail position may cause the autopilot'scontrol error.Monitor the wind direction when using

11. OPERATION 1.1 WIND Mode The wind mode keeps the direction same as receiving wind direction. Note: The WIND mode requires wind sensor data as b

1. OPERATION 2 1.1.2 Displays (Navpilot-500) There are four types of displays; Normal display, Normal display 2, Data display and Graphic display. (

1. OPERATION 31. In the WIND mode, press the [MENU] key to show the WIND mode menu. For Navpilot-511/520, press the [TURN/MENU] key twice to show th

1. OPERATION 4 Wind directionFAST mode (Starboard)SLOW mode (Starboard)Degrees set on RATE OF FAST TACKDegrees set on RATE OF SLOW TACKWind direction

1. OPERATION 5Setting the rate of turn for FAST/SLOW tacking The rate of turn is preset as 3º for SLOW and 20º for FAST. If you need to change the va

1. OPERATION 6 Setting the fixed tack angle The fixed tacking mode requires the setting of tacking angle. You can set the angle on the menu. 1. Rot

1. OPERATION 7The turning direction is determined according to the heading at the time the [TURN] ([TURN/MENU] for Navpilot 511/520) key is pressed,