Furuno NETCONTROLLER B042-004 Manual do Utilizador descarregar pdf (Página 33)

3. INITIAL SETTINGS

3-7

d) Use [+] or [-] to set the value for the frequency which is connected, and then press [!] or

["] to close the dialog box. (Available range: HIGH; 40 – 220 kHz, LOW; 25 – 220 kHz)

e) To operate the transducer in reduced power (for example, when vessel is in dry dock),

press ["] to select PWR REDUCTION, and then press [+] or [-] to open the dialog box.

OFF ON

f) Press [+] or [-] to turn the power reduction ON, and then press [!] or ["] to close the

dialog box.

6. Confirm settings and turn off the power.

3.3 Water Temperature Sensor Setting

If a water temperature sensor is connected, set up as follows:

1. Turn on the power and turn the [FUNCTION] switch to the MENU position.

2. Press [!] and [+] to select SYSTEM at the top of the screen.

3. Press ["] to select TEMP SETTING, and then press [+] to open that menu.

TEMP SETTING

DISP ALM TX/RX E/S SYSTEM

Select temperature unit.

TEMP UNIT : ˚F

TEMP INPUT : SENSOR

TEMP ADJUST : +0.00˚F (-20 +20)

TEMP OUTPUT : OFF

TEMP READOUT : OFF

TEMP GRAPH : OFF

TEMP COLOR : STD

[-/+]: Change set, [EXIT]: Exit

TEMP SETTING menu

4. The cursor is selecting TEMP UNIT; press [+] or [-] to open the dialog box.

C F

5. Press [+] or [-] to select the temperature unit, and then press [!] or ["] to close the

dialog box.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Sem comentários

Furuno NETCONTROLLER B042-004 Manual do Utilizador Página 33